NAVIGATION SYSTEM > Stereo Component Amplifier Power Source Circuit |


| 1.CHECK VEHICLE CONDITION |
Check the vehicle condition.
| Result | Proceed to |
| for 7 or 9 Speakers | A |
| for 12 Speakers | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J144-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J144-4 (+B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Stereo Component Amplifier Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY) |
Disconnect the J144 stereo component amplifier assembly connector.
Disconnect the J133 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J144-9 (AMP) - J133-9 (AMP) | Always | Below 1 Ω |
| J144-9 (AMP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J143-6 (GND) - Body ground | Always | Below 1 Ω |
| J143-7 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J142-1 (+B) - J143-6 (GND) | Always | 11 to 14 V |
| J142-5 (+B2) - J143-6 (GND) | Always | 11 to 14 V |
| J141-12 (ACC) - J143-6 (GND) | Ignition switch ACC | 11 to 14 V |
| *a | Front view of wire harness connector (to Stereo Component Amplifier Assembly) |
|
| ||||
| OK | ||
| ||