NAVIGATION SYSTEM > Parking Brake Switch Circuit |

| 1.CHECK VEHICLE SIGNAL (OPERATION CHECK) |
![]() |
Display the "Vehicle Signal Check Mode" screen (Click here).
Check that the display changes between ON and OFF according to the parking brake operation.
| Parking Brake Condition | Display |
| Applied | ON |
| Released | OFF |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY) |
Disconnect the J135 navigation receiver assembly connector.
Disconnect the A5 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J135-15 (PKB) - A5-1 | Always | Below 1 Ω |
| J135-15 (PKB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT PARKING BRAKE SWITCH ASSEMBLY |
Remove the parking brake switch assembly (Click here).
Inspect the parking brake switch assembly (Click here).
|
| ||||
| OK | ||
| ||