Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on.

  4. Turn the Techstream on.

  5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.

    HINT:
    The blind spot monitor sensor RH and the blind spot monitor sensor LH both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.

  6. Check for DTCs (Click here).


CLEAR DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on.

  4. Turn the Techstream on.

  5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.

  6. Clear the DTCs.