Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the blind spot monitor sensor.

WIRING DIAGRAM


E244551E13


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH, BLIND SPOT MONITOR SENSOR RH - BATTERY AND BODY GROUND)


    E283775E03
  1. Disconnect the blind spot monitor sensor RH connector.

  1. Disconnect the blind spot monitor sensor LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S6-5 (BRB) - Body ground
    Ignition switch ON
    11 to 14 V
    S6-5 (BRB) - Body ground
    Ignition switch off
    Below 1 V
    S5-5 (BLB) - Body ground
    Ignition switch ON
    11 to 14 V
    S5-5 (BLB) - Body ground
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S6-10 (BRGD) - Body ground
    Always
    Below 1 Ω
    S5-10 (BLGD) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Blind Spot Monitor Sensor RH)
*b
Front view of wire harness connector
(to Blind Spot Monitor Sensor LH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)