Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > INSTALLATION

for Preparation Click here


NOTICE:
  1. Avoid any impact to the blind spot monitor sensor.
  2. Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



1. INSTALL BLIND SPOT MONITOR SENSOR LH
  1. Install the blind spot monitor sensor LH with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL BLIND SPOT MONITOR SENSOR RH
  1. Install the blind spot monitor sensor RH with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



3. INSTALL REAR BUMPER EXTENSION INSERT LH
  1. Install the rear bumper extension insert LH with the 8 clips.



4. INSTALL REAR BUMPER EXTENSION INSERT RH

HINT:
Use the same procedure described for the LH side.



5. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Attach the 2 claws to install the license plate assembly LH.



6. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



7. INSTALL REAR BUMPER PAD SUB-ASSEMBLY LH
  1. Attach the 12 claws and 2 guides to install the rear bumper pad sub-assembly LH.

  1. Install the 3 clips.



8. INSTALL REAR BUMPER PLATE LH
  1. Attach the 3 claws and clip to install the rear bumper plate LH.



9. INSTALL REAR BUMPER PLATE RH

HINT:
Use the same procedure described for the LH side.



10. INSTALL REAR BUMPER COVER
  1. w/ Towing Package:

    1. Using an engine lifter or equivalent, install the rear bumper cover with the 12 bolts.

      Torque:
      153 N*m{ 1560 kgf*cm , 113 ft.*lbf }

      NOTICE:
      1. Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.
      2. Be sure to perform the operation with 2 persons or more.
      3. Be careful not to damage the rear bumper cover.

  1. w/o Towing Package:

    1. Using an engine lifter or equivalent, install the rear bumper cover with the 8 bolts.

      Torque:
      153 N*m{ 1560 kgf*cm , 113 ft.*lbf }

      NOTICE:
      1. Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.
      2. Be sure to perform the operation with 2 persons or more.
      3. Be careful not to damage the rear bumper cover.



11. INSTALL WIRING HARNESS CONNECTOR (w/ Towing Package)
  1. Attach the 2 claws to install the wiring harness connector.

  1. Connect the connector.



12. INSTALL CONNECTOR COVER (w/o Towing Package)

HINT:
Use the same procedure described for the wiring harness connector.