Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > REMOVAL

for Preparation Click here


NOTICE:
  1. Avoid any impact to the blind spot monitor sensor.
  2. Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



1. REMOVE CONNECTOR COVER (w/o Towing Package)

HINT:
Use the same procedure described for the wiring harness connector.



2. REMOVE WIRING HARNESS CONNECTOR (w/ Towing Package)


    B355009
  1. Disconnect the connector.

  1. Detach the 2 claws and remove the wiring harness connector.



3. REMOVE REAR BUMPER COVER


    B355010
  1. Disconnect the 2 connectors and detach the clamp.



  1. w/ Towing Package:



    1. Using an engine lifter or equivalent, remove the 12 bolts and rear bumper cover.


      B355012

      NOTICE:
      1. Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.
      2. Be sure to perform the operation with 2 persons or more.
      3. Be careful not to damage the rear bumper cover.



  1. w/o Towing Package:



    1. Using an engine lifter or equivalent, remove the 8 bolts and rear bumper cover.


      B355011

      NOTICE:
      1. Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.
      2. Be sure to perform the operation with 2 persons or more.
      3. Be careful not to damage the rear bumper cover.



4. REMOVE REAR BUMPER PLATE LH


    B355013
  1. Detach the 3 claws and clip and remove the rear bumper plate LH.



5. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedure described for the LH side.



6. REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH


    B355014
  1. Remove the 3 clips.

  1. Detach the 12 claws and 2 guides and remove the rear bumper pad sub-assembly LH as shown in the illustration.



7. REMOVE LICENCE PLATE LIGHT ASSEMBLY LH


E281366
  1. Detach the 2 claws.



    E281367
  1. Disconnect the connector and remove the license plate light assembly LH.



8. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



9. REMOVE REAR BUMPER EXTENSION INSERT LH


    B355019
  1. Remove the 8 clips and rear bumper extension insert LH.



10. REMOVE REAR BUMPER EXTENSION INSERT RH

HINT:
Use the same procedure described for the LH side.



11. REMOVE BLIND SPOT MONITOR SENSOR LH


    B354805
  1. Disconnect the connector.

  1. Remove the 3 nuts and blind spot monitor sensor LH.



12. REMOVE BLIND SPOT MONITOR SENSOR RH


    B354806
  1. Disconnect the connector.

  1. Remove the 3 nuts and blind spot monitor sensor RH.