FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE FRONT POWER SEAT CONTROL SYSTEM |
Customizing with the Techstream.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / Seat.
Select the setting by referring to the table below.
| Tester Display | Default | Content | Setting | Relevant ECU |
| Seat Travel Distance | Normal | Allows customizing of the seat movement distance for the power easy access system. | OFF or Short or Normal | Main body ECU (driver side junction block assembly) |
Customizing with the Multi-display
Turn the ignition switch to ON.
Enter the following menus: SET UP / Vehicle / Vehicle Customization / Other vehicle settings.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Driver's Seat Easy Exit | Full | Allows customization of the seat movement distance for the power easy access system. | Full or Partial or Off | Main body ECU (driver side junction block assembly) |