Home › ENGINE ยท 3UR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > DISASSEMBLY

for Preparation Click here



1. REMOVE MONOLITHIC CONVERTER PROTECTOR (for Bank 1)
  1. Remove the 4 bolts, 4 nuts, lower monolithic converter protector, upper monolithic converter protector, 2 No. 1 converter protector stays and 2 No. 2 converter protector stays from the front No. 2 exhaust pipe assembly.



2. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 1)
  1. Remove the 4 bolts, 4 nuts, lower No. 1 monolithic converter protector, upper No. 1 monolithic converter protector and 4 No. 1 converter protector stays from the front No. 2 exhaust pipe assembly.



3. REMOVE MONOLITHIC CONVERTER PROTECTOR (for Bank 2)
  1. Remove the 4 bolts, 4 nuts, lower monolithic converter protector, upper monolithic converter protector, 2 No. 1 converter protector stays and 2 No. 2 converter protector stays from the front exhaust pipe assembly.



4. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 2)
  1. Remove the 4 bolts, 4 nuts, lower No. 1 monolithic converter protector, upper No. 1 monolithic converter protector and 4 No. 1 converter protector stays from the front exhaust pipe assembly.