EXHAUST PIPE > REASSEMBLY |
| 1. INSTALL NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 2) |
Install the 4 No. 1 converter protector stays to the front exhaust pipe assembly.
Install the lower No. 1 monolithic converter protector and upper No. 1 monolithic converter protector with the 4 bolts and 4 nuts.
![]() |
| *a | Top |
| *b | LH Side of Vehicle |
| *c | 33.7 to 41.7° |
| 2. INSTALL MONOLITHIC CONVERTER PROTECTOR (for Bank 2) |
Install the 2 No. 1 converter protector stays and 2 No. 2 converter protector stays to the front exhaust pipe assembly.
Install the lower monolithic converter protector and upper monolithic converter protector with the 4 bolts and 4 nuts.
![]() |
| *a | Top |
| *b | LH Side of Vehicle |
| *c | -2.6 to 5.4° |
| 3. INSTALL NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 1) |
Install the 4 No. 1 converter protector stays to the front No. 2 exhaust pipe assembly.
Install the lower No. 1 monolithic converter protector and upper No. 1 monolithic converter protector with the 4 bolts and 4 nuts.
![]() |
| *a | Top |
| *b | LH Side of Vehicle |
| *c | 45.5 to 53.5° |
| 4. INSTALL MONOLITHIC CONVERTER PROTECTOR (for Bank 1) |
Install the 2 No. 1 converter protector stays and 2 No. 2 converter protector stays to the front No. 2 exhaust pipe assembly.
Install the lower monolithic converter protector and upper monolithic converter protector with the 4 bolts and 4 nuts.
![]() |
| *a | Top |
| *b | LH Side of Vehicle |
| *c | 16.3 to 24.3° |