Home › ENGINE ยท 3UR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 2)
  1. Install the 4 No. 1 converter protector stays to the front exhaust pipe assembly.



  1. Install the lower No. 1 monolithic converter protector and upper No. 1 monolithic converter protector with the 4 bolts and 4 nuts.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }


    HINT:
    A306320E01
    Install the No. 1 monolithic converter protector within the angle range specified in the illustration.

    Text in Illustration 
    *a
    Top
    *b
    LH Side of Vehicle
    *c
    33.7 to 41.7°



2. INSTALL MONOLITHIC CONVERTER PROTECTOR (for Bank 2)
  1. Install the 2 No. 1 converter protector stays and 2 No. 2 converter protector stays to the front exhaust pipe assembly.



  1. Install the lower monolithic converter protector and upper monolithic converter protector with the 4 bolts and 4 nuts.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }


    HINT:
    A306319E01
    Install the monolithic converter protector within the angle range specified in the illustration.

    Text in Illustration 
    *a
    Top
    *b
    LH Side of Vehicle
    *c
    -2.6 to 5.4°



3. INSTALL NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 1)
  1. Install the 4 No. 1 converter protector stays to the front No. 2 exhaust pipe assembly.



  1. Install the lower No. 1 monolithic converter protector and upper No. 1 monolithic converter protector with the 4 bolts and 4 nuts.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }


    HINT:
    A307752E01
    Install the No. 1 monolithic converter protector within the angle range specified in the illustration.

    Text in Illustration 
    *a
    Top
    *b
    LH Side of Vehicle
    *c
    45.5 to 53.5°



4. INSTALL MONOLITHIC CONVERTER PROTECTOR (for Bank 1)
  1. Install the 2 No. 1 converter protector stays and 2 No. 2 converter protector stays to the front No. 2 exhaust pipe assembly.



  1. Install the lower monolithic converter protector and upper monolithic converter protector with the 4 bolts and 4 nuts.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }


    HINT:
    A306321E01
    Install the monolithic converter protector within the angle range specified in the illustration.

    Text in Illustration 
    *a
    Top
    *b
    LH Side of Vehicle
    *c
    16.3 to 24.3°