Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

for Preparation Click here


DESCRIPTION

This DTC is detected if communication is lost between the ECM and skid control ECU.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
U0100
  1. Ignition switch ON
  2. Communication is lost between ECM and 4 wheel drive control ECU
  3. 5 seconds or more
  4. 1 trip detection logic
CAN communication system
U0122
  1. Ignition switch ON
  2. Communication is lost between skid control ECU and 4 wheel drive control ECU
  3. 0.7 seconds or more
  4. 1 trip detection logic
CAN communication system

INSPECTION PROCEDURE

NOTICE:
  1. When the data in the ECM or skid control ECU is being overwritten, the indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.
  2. Clear all DTCs, since DTCs are stored after the data in the ECM or skid control ECU is overwritten.

1.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)