Home › BODY ELECTRICAL › LIGHTING › DAYTIME RUNNING LIGHT RELAY

DAYTIME RUNNING LIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT NO. 1 DAY TIME RUNNING LIGHT RELAY


E281418
  1. Remove the No. 1 day time running light relay from the engine room relay box.



    E277744E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied to terminals 1 and 2
      10 kΩ or higher
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the No. 1 day time running light relay.

  1. Install the No. 1 day time running light relay to the engine room relay box.