Home › BODY ELECTRICAL › LIGHTING › DOME RELAY

DOME RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DOME LIGHT RELAY


E281417
  1. Remove the dome light relay from the engine room relay box.



    E277744E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied to terminals 1 and 2
      10 kΩ or higher
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the dome light relay.

  1. Install the dome light relay to the engine room relay box.