Home › BODY › SEAT › SEAT VARIABLE CUSHION SWITCH

SEAT VARIABLE CUSHION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT VARIABLE CUSHION SWITCH


    B356629E01
  1. Check the resistance of the seat variable cushion switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      2 (B) - 5 (H)
      Front switch on
      Below 1 Ω
      3 (R) - 4 (E2)
      1 (E) - 5 (H)
      Neutral
      3 (R) - 4 (E2)
      1 (E) - 5 (H)
      Rear switch on
      2 (B) - 3 (R)

      If the result is not as specified, replace the seat variable cushion switch.
      Text in Illustration 
      *1
      Front Switch
      *2
      Rear Switch
      *a
      Component without wire harness connected
      (Seat Variable Cushion Switch)