Home › RESTRAINTS › SEAT BELT › CHILD RESTRAINT SEAT ANCHOR BRACKET (for CrewMax RH Side)

CHILD RESTRAINT SEAT ANCHOR BRACKET (for CrewMax RH Side) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY


    B355165
  1. Install the tether anchor bracket sub-assembly with the bolt.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }



2. INSTALL REAR SEAT HEADREST ASSEMBLY
  1. Push the 2 lock release buttons to release the lock, and then install the rear seat headrest assembly.



3. INSTALL REAR SEAT ASSEMBLY RH
  1. Install the rear seat assembly RH with the 4 bolts.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Be careful not to damage the vehicle body.



    B355146
  1. Pull the No. 1 reclining adjuster release handle RH and fold down the seat cushion.