Home › DRIVE LINE › WF1AM TRANSFER › TRANSFER SHIFT ACTUATOR ASSEMBLY

TRANSFER SHIFT ACTUATOR ASSEMBLY > REMOVAL

for Preparation Click here


NOTICE:
Change the vehicle to 2WD mode before removing the transfer shift actuator assembly.
If the vehicle cannot be changed to 2WD mode, since the new transfer shift actuator assembly is set in the 2WD position, connect all the connectors to the vehicle side wire harnesses to set the new transfer shift actuator assembly to the drive state of the vehicle before installing the new transfer shift actuator assembly.



1. REMOVE TRANSFER SHIFT ACTUATOR ASSEMBLY


    C291190
  1. Disconnect the 3 connectors and detach the 2 clamps.

  1. Remove the 4 bolts and transfer shift actuator assembly.