Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    U0416    Invalid Data Received from Vehicle Dynamics Control Module

for Preparation Click here


DESCRIPTION

This DTC is detected if a wheel speed malfunction signal is sent from the skid control ECU.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
U0416
  1. Ignition switch ON
  2. Wheel speed sensor malfunction signals from skid control ECU are received
  3. 0.06 secs. or more (malfunction signal received 1 or more times)
  4. 1 trip detection logic
  1. CAN communication system
  2. Vehicle stability control system

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)