DTC P2109 Throttle / Pedal Position Sensor "A" Minimum Stop Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2109 | The ISC learned value is approximately 3 times larger than normal even though the actual intake air amount during idling is within the normal range (up to 1.5 times the normal amount) (5 trip detection logic). | Throttle body with motor assembly |
| 1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO P2109) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| Only DTC P2109 is output | A |
| DTC P2109 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK FREEZE FRAME DATA |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Using the Techstream, check "ISC Learning Value" in the freeze frame data (Click here).
| NEXT | |
| 3.REMOVE FOREIGN OBJECT (CLEAN THROTTLE BODY WITH MOTOR ASSEMBLY) |
![]() |
Clean off any deposits from the inside of the throttle body with motor assembly.
Push open the throttle valve and wipe off any carbon from the valve and bore using a cloth soaked in non-residue solvent.
| *1 | Bore |
| *2 | Valve |
| *a | Reference |
| *b | Throttle Body with Motor Assembly Cross-section Diagram |
| *c | When valve fully opened |
| *d | Deposits |
| *e | Do not directly apply cleaner |
| NEXT | |
| 4.READ VALUE USING TECHSTREAM (ISC LEARNING VALUE) |
Perform "Inspection After Repair" after cleaning the throttle body with motor assembly (Click here).
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / ISC Learning Value.
Read the value.
|
| ||||
| OK | ||
| ||