Home › Engine / Hybrid System › M15A-FKS (FUEL) › FUEL SYSTEM
NM3700E _51 Engine / Hybrid System _094230 M15A-FKS FUEL _0443899 FUEL SYSTEM CO CONTROL F

M15A-FKS FUEL  FUEL SYSTEM  CONTROL  D-4 SYSTEM  


FUNCTION OF MAIN COMPONENTS


a.

The D-4 system has the following components and functions:

Component Function
Fuel Pump (for Low Pressure) Sends fuel (400 kPa) from the fuel tank sub-assembly to the fuel pump assembly (for high pressure).
Fuel Pump Assembly (for High Pressure) Increases the pressure of the fuel from the fuel pump assembly (for low pressure) to a pressure of 2.4 to 20 MPa and sends it to the fuel delivery pipe sub-assembly.
Spill Control Valve Closes and opens the fuel flow path to the fuel delivery pipe sub-assembly in accordance with signals from the ECM.
Fuel Delivery Pipe Sub-assembly Delivers the high-pressure fuel to the fuel injector assembly.
Fuel Pressure Pulsation Damper Assembly Reduces fuel pressure fluctuation (pulsation) and noise.
Fuel Pressure Sensor Senses the fuel pressure and outputs a signal to the ECM.
Fuel Relief Valve Assembly If the fuel pressure in the delivery pipe is abnormally high, the fuel relief valve assembly discharges some of the fuel to the fuel tank sub-assembly in order to limit the pressure.
Fuel Injector Assembly Injects a calculated (by the ECM) quantity of 2.4 to 20 MPa (high pressure) fuel directly into the combustion chamber.
ECM Depending on the vehicle condition, and based on signals from various sensors, the ECM calculates the optimal injection timing and volume, and controls the fuel injector assembly and fuel pump assembly (for high pressure).



FUNCTION


a.

The Direct injection 4-stroke gasoline engine (D-4) system is an engine in which highly pressurized fuel is injected directly into the combustion chamber. Fuel injection timing, air-fuel ratio, throttle valve opening angle, etc. are controlled in a comprehensive manner, realizing both high output and low emissions.


b.

The fuel atomized by the high-pressure 6 holes nozzle fuel injector assembly is injected into the combustion chamber, spreading wide and winding up a mass of the air. Highly pressurized and atomized fuel spreads through the whole combustion chamber by its own energy and high speed tumble flow, then is mixed with the intake air, achieving the ideal combustion in all driving ranges.

W144270C01
1.667,2.583 1.833,2.583 1.833,2.583 2.604,2.073 true 1.49,2.521 1.802,2.677 0.313,0.156 10 false *1
*1 Fuel Injector Assembly - -