Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM
NM3700E _51 Engine / Hybrid System _093838 HYBRID / BATTERY CONTROL _0443966 HYBRID BATTERY SYSTEM GE GENERAL F

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

Hybrid Battery

i.

A Lithium-ion battery has been provided.


ii.

Due to a battery ECU assembly that monitors the HV battery condition (battery voltage, battery current value, temperature) and controls the charging and discharging amount to maintain a certain charging condition, charging from external sources is generally not necessary.


iii.

A small and high-efficiency hybrid battery has been installed under the rear seat.


iv.

The hybrid battery location increases luggage space capacity and contributes to excellent handling stability due to a lower center of gravity.


v.

The HV battery has high power and density, light weight and long life characteristics, compensates the vehicle drive energy and stores regenerative energy.




SPECIFICATION


a.

HV Battery

Item Specification
Type Lithium-ion Battery
Cell Quantity 48 Cells (24 Cells x 2 Stacks)
Nominal Voltage V 177.6
Battery Capacity (3HR) Ah 4.3



MAIN FEATURES


a.

Cooling System

i.

A small and high-output brushless motor has been adopted for the battery cooling blower assembly.


ii.

To ensure the proper performance of the HV battery while it generates heat during repetitive charge and discharge cycles, a dedicated cooling system is used for the HV battery.


iii.

Air is taken in from the trim located under the left rear seating position for more efficient cooling.


iv.

An air filter has been provided on the cooling air intake bezel.

NOTICE:
·

There is an air intake vent under the left side of the rear seat for the purpose of cooling the hybrid battery.

Do not place anything on top that could block the air intake vent.

If the air intake vent becomes blocked, the hybrid battery may overheat, leading to a reduction in hybrid battery output, and be damage.

·

Clean the air intake vent regularly using a vacuum cleaner to prevent the hybrid battery from overheating.

·

Do not get water or foreign materials in the air intake vent as this may cause a short circuit and damage the hybrid battery.

·

Do not carry large amounts of water such as water cooler bottles in the vehicle. If water spills onto the hybrid battery, the battery may be damaged.

·

Do not drive the vehicle on flooded roads or in other locations in which water could enter the cabin. Doing so may cause a malfunction in the hybrid battery.

·

Do not use with the air intake vent cover (battery service hole cover) or air filter removed. If dust or foreign matter is sucked in, it may reduce the cooling performance of the hybrid battery or cause a malfunction in it.




v.

The airflow volume from the battery cooling blower assembly is optimally controlled according to the HV battery temperature via the duty signal from battery ECU assembly to achieve a high level of cooling performance.


vi.

The cooling pathways have been optimized to achieve both a quiet cabin and ample cooling.


vii.

The exhaust cooled by the HV battery module is distributed underneath the carpet, luggage room and in the rear door scuff plate LH and RH.

W147045C01
0.344,0.333 0.583,0.333 0.583,0.333 1.781,0.792 true 6.156,3.646 5.917,3.646 5.917,3.646 5.292,2.427 true 2.156,4.385 1.958,4.385 1.958,4.385 1.552,5.219 true 4.146,4.51 3.948,4.51 3.948,4.51 3.427,5.552 true 6.281,3.563 6.594,3.76 0.313,0.198 10 false *2 2.854,2.677 3.094,2.885 0.24,0.208 10 true *a 1.292,0.781 1.51,0.99 0.219,0.208 10 true *c 0.146,0.26 0.458,0.458 0.313,0.198 10 false *1 4.208,4.427 4.521,4.625 0.313,0.198 10 false *3 4.458,1.354 4.708,1.563 0.25,0.208 10 true *b 5.896,2.813 6.135,3.01 0.24,0.198 10 true *d 2.229,4.302 2.542,4.5 0.313,0.198 10 false *2
*1 No. 1 HV Battery Hose *2 Battery Cooling Blower Assembly
*3 HV Battery Stack - -
*a to Under Carpet *b to Luggage Room
*c to Inner Side of Rear Door Scuff Plate Inside RH *d to Inner Side of Rear Door Scuff Plate Inside LH
V100135

Cooling Air Flow - -




b.

Service Plug Grip

i.

By removing the service plug grip before performing any inspection or service, the high-voltage circuit is shut off, thus ensuring safety during service.

CAUTION:
·

A charge remains in the high-voltage capacitor in the hybrid motor control inverter assembly after the high-voltage circuits are cut off. When servicing a hybrid vehicle, after removing the service plug grip, wait at least 10 minutes to allow the capacitor to discharge before beginning work.

·

When working on the high voltage system, take safety precautions to prevent electric shocks, such as wearing insulated gloves.

·

For further details on how to handle the service plug grip and other safety cautions, refer to the Repair Manual.



NOTICE:
·

The service plug grip should never be removed when the system is in the on (READY) state.

·

After removing the service plug grip, turning the ignition switch on (READY) may cause a malfunction. Do not turn the ignition switch on (READY) unless instructed by the Repair Manual.




ii.

The service plug grip is connected in the battery module circuit and is used for manually shutting off the high-voltage circuit. This ensures safety during service.


iii.

An interlock switch is provided on the service plug grip. When the grip section is unlocked, the interlock switch is turned off and the hybrid vehicle control ECU shuts off the system main relays. However, to ensure safety, make sure to turn the ignition switch off before removing the service plug grip.

W147046C01
3.948,2.917 5.75,2.917 true 2.583,5.417 2.917,5.417 true 3.927,2.229 5.677,2.229 true 4.979,6.292 5.292,6.448 0.313,0.156 10 false *1 5.823,2.833 6.135,2.99 0.313,0.156 10 false *2 5.729,5.906 6.042,6.063 0.313,0.156 10 false *3 5.781,4.604 6.094,4.76 0.313,0.156 10 false *4 2.969,5.344 3.281,5.5 0.313,0.156 10 false *1 0.698,5.385 1.01,5.542 0.313,0.156 10 false *3 5.729,2.135 6.042,2.292 0.313,0.156 10 false *1
*1 Service Plug Grip *2 Rear Under Side Cover LH
*3 Interlock Switch *4 HV Battery