CONSTRUCTION
Lubrication of the gear train, oil seal and bearing are performed by oil scraping lubrication by the counter driven gear and differential ring gear.
A fluid catch tank is used in this drive unit in order to supply fluid in a stable manner. The fluid catch tank temporarily stores the ATF that is slung up, and supplies ATF in a stable manner to the different parts of the gear train.
| *1 | Fluid Catch Tank | *2 | Counter Driven Gear |
| *3 | Differential Ring Gear | - | - |
| *a | Scraping lubrication method with differential Ring Gear | *b | Scraping lubrication method with counter driven gear |
| *c | Gear portion cross section | *d | Initial oil level |
| *e | High speed oil level | - | - |
| Vehicle Speed | Scraping lubrication | Effect | |
|---|---|---|---|
| Differential Ring Gear | Counter Driven Gear | ||
| Stop | - | - | At vehicle speeds of less than 10 km/h during which the rear motor is always used, the motor is immersed in oil for proactive cooling. |
| Low Speed | Small | Large | Oil that is scraped up by the counter driven gear enters the oil catch tank, lowering the oil level in the gear chamber and motor chamber, and suppressing the oil agitation resistance on the rotating bodies. |
| High Speed | Large | Small | The oil level further decreases and oil agitation by the counter driven gear is also reduced. During high speed driving, lubrication is mainly performed by scraping with the relatively low rotational speed differential ring gear, realizing low drag. |