FUNCTION
Models with Stop and Start System
When the ignition switch is pressed, the certification ECU (smart key ECU assembly) receives a start signal.
When the certification ECU (smart key ECU assembly) detects a start signal (SSW1, SSW2), the certification ECU (smart key ECU assembly) outputs a No. 1 ST relay (starter relay) drive signal (STAR). The No. 1 ST relay (starter relay) activates the starter assembly when it receives this signal. At this time, the certification ECU (smart key ECU assembly) turns off the ACC relay by turning off the power sent from the ACCD terminal. The ACC relay is turned off to prevent flickering of the meter, clock and audio system.
When starting the engine during idling stop control, the engine stop and start ECU sends operation signals to the No. 1 ST relay (starter relay) according to the vehicle condition to operate the starter assembly.
When communication between the certification ECU (smart key ECU assembly) and ECM stops, the certification ECU (smart key ECU assembly) uses the engine speed (NEO) signal received from the ECM via a direct line to determine when to turn off the starter.
While cranking, the certification ECU (smart key ECU assembly) continues energizing the No. 1 ST relay (starter relay) until it is determined that the engine has started. When the certification ECU (smart key ECU assembly) has judged that the engine has started, the certification ECU (smart key ECU assembly) stops energizing the No. 1 ST relay (starter relay).
The crank hold time and engine speed when it has been determined that the engine has started successfully are determined according to the engine coolant temperature.
If the engine does not start even though the starter has cranked for 30 seconds, the No. 1 ST relay (starter relay) is turned off to protect the starter motor.
Models without Stop and Start System
When the ignition switch is pressed, the certification ECU (smart key ECU assembly) receives a start signal.
When the certification ECU (smart key ECU assembly) detects a start signal (SSW1, SSW2), the certification ECU (smart key ECU assembly) outputs a No. 1 ST relay (starter relay) drive signal (STAR). The No. 1 ST relay (starter relay) activates the starter assembly when it receives this signal. At this time, the certification ECU (smart key ECU assembly) turns off the ACC relay by turning off the power sent from the ACCD terminal. The ACC relay is turned off to prevent flickering of the meter, clock and audio system.
When communication between the certification ECU (smart key ECU assembly) and ECM stops, the certification ECU (smart key ECU assembly) uses the engine speed (NEO) signal received from the ECM via a direct line to determine when to turn off the starter.
While cranking, the certification ECU (smart key ECU assembly) continues energizing the No. 1 ST relay (starter relay) until it is determined that the engine has started. When the certification ECU (smart key ECU assembly) has judged that the engine has started, the certification ECU (smart key ECU assembly) stops energizing the No. 1 ST relay (starter relay).
If the engine does not start even though the starter has cranked for 30 seconds, the No. 1 ST relay (starter relay) is turned off to protect the starter motor.