Home › Drivetrain › EC6D (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › from 2021.07
NM3700E _52 Drivetrain _107006 EC6D MANUAL TRANSMISSION / TRANSAXLE _0486171 MANUAL TRANSAXLE SYSTEM GE GENERAL F

EC6D MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The EC6D 6-speed manual transaxle is used.


b.

An Intelligent Manual Transmission (iMT) system is used, this system for manual transmission vehicles adjusts the engine speed during a shift change to match the transmission speed, achieving a smooth shift change.


c.

A Gear Shift Indicator system is used.



SPECIFICATION


Item Specification
Mesh Type Forward Constant Mesh
Reverse Sliding Mesh
Gear Ratio 1st 3.538
2nd 2.045
3rd 1.392
4th 1.029
5th 0.818
6th 0.700
Reverse 3.333
Differential Gear Ratio 4.538
Synchromesh Mechanism Type 1st, 2nd Triple-cone
3rd, 4th, 5th, 6th Single-cone
Oil Capacity Liters (US qts, Imp. qts) 2.1 (2.2, 1.8)
Oil Type "TOYOTA Genuine Manual Transmission Gear Oil LV" or "API GL-4 and SAE 75W"
Weight kg 44.1


PRECAUTION


a.

Limitations of the iMT

i.

In some situations, such as when there is a delay between clutch operation and shift operation, or when the vehicle is driven with the shift lever in neutral (N) and then a shift operation is performed, the system may not detect that the driver performed a shift operation, but this is not a malfunction.


ii.

After the iMT system has adjusted the engine speed, after a specified period of time has elapsed, system control will end, even in this situation, if the clutch is re-engaged and a new shift operation is detected, the system will operate again.


iii.

If the clutch pedal is not fully released, or not firmly depressed, the system may not operate.


iv.

This is not a system for preventing improper shift operations.


v.

This is not a system for preventing engine over-revving (excessively high engine speed).


vi.

If the engine speed is not synchronized, shift shock may occur, perform clutch operations properly and do not over-rely on the system.


vii.

When the ECM detects a malfunction, the ECM prohibits iMT system operation. In this case, in the combination meter displays the message.