CONSTRUCTION
The parking brake actuator assembly consists of a motor, a timing belt, each gear, a planetary gear and a joint.
The parking brake actuator assembly generates the necessary torque with the planetary gear and each gear according to signals from the parking brake ECU*1 or skid control ECU*2*3, and transmits the rotational torque to the brake caliper via the joint.
When the parking brake actuator assembly receives the lock signal from the parking brake ECU*1 or skid control ECU*2, the motor rotates the joint counterclockwise. This rotational torque is transmitted to the bolt and nut inside the brake caliper and thereby converted to linear force to drive the piston, which locks the parking brake.
When the parking brake actuator assembly receives the release signal from the parking brake ECU*1 or skid control ECU*2*3, the motor rotates the joint clockwise. This rotational torque returns the bolt and nut inside the brake caliper to their original positions, releasing the hold on the piston and thus releasing the parking brake.
*1: HV Models (TMC Made)
*2: HV Models (TMMF Made)
*3: Gasoline Models
| *1 | No. 2 Pinion Gear and No. 1 Gear Sub-assembly | *2 | Shaft Gear and No. 2 Gear Sub-assembly |
| *3 | Ring Gear | *4 | Planetary Gear |
| *5 | Carrier Sub-assembly | *6 | Joint (Output Shaft) |
| *7 | Motor | *8 | No. 1 Pinion Gear |
| *a | The illustrations shown are examples only. | - | - |