1.INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
No. 1 transmission shift switch assembly:
| *a | Component without harness connected
(No. 1 Transmission Shift Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1(SDN) - A-2(ECC) | "-" (Down shift) shift paddle switch operated and held | Below 2.5 Ω |
| A-1(SDN) - A-2(ECC) | "-" (Down shift) shift paddle switch not operated | 1 MΩ or higher |
| A-1(SDN) - A-3(ECC1) | "-" (Down shift) shift paddle switch operated and held | Below 2.5 Ω |
| A-1(SDN) - A-3(ECC1) | "-" (Down shift) shift paddle switch not operated | 1 MΩ or higher |
If the result is not as specified, replace the No. 1 transmission shift switch assembly.
No. 2 transmission shift switch assembly:
| *a | Component without harness connected
(No. 2 Transmission Shift Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1(SUP) - 2(ECC) | "+" (Up shift) shift paddle switch operated and held | Below 2.5 Ω |
| A-1(SUP) - 2(ECC) | "+" (Up shift) shift paddle switch not operated | 1 MΩ or higher |
If the result is not as specified, replace the No. 2 transmission shift switch assembly.