89413M
1.INSPECT TRANSMISSION REVOLUTION SENSOR (NOUT)
Pre-procedure1
Connect the battery to the transmission revolution sensor (NOUT) as shown in the illustration.
| *1 | Battery | *2 | Ammeter |
| *a | Component without harness connected
(Transmission Revolution Sensor (NOUT)) |
*b | Magnet |
| *c | 5 mm (0.197 in.) or less | - | - |
Wave a magnet left and right 5 mm (0.197 in.) or less from the tip of the transmission revolution sensor (NOUT) to output a high/low signal while measuring the current.
Make sure to wave the magnet during the inspection. The current will not change unless the magnet is moved as shown in the illustration.
Procedure1
Measure the current according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D62)Location & Routingewd_type=routing;type=c;code=D62 Click Connector(D62)Engine Compartment>Engine Wire>Transmission Revolution Sensor (NOUT)ewd_type=component;type=c;code=D62;pinno=1,2 |
||
| D62-1(NOO) - D62-2(NOB) | Low Signal | 4 to 8 mA |
| D62-1(NOO) - D62-2(NOB) | High Signal | 12 to 16 mA |
If the result is not as specified, replace the transmission revolution sensor (NOUT).
Post-procedure1
None.