84040
1.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
Check that the LED illuminates.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
Apply auxiliary battery voltage to the multiplex network master switch assembly and check that the LED illuminates.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(K5)Location & Routingewd_type=routing;type=c;code=K5 Click Connector(K5)Body>Front Door Wire RH / Television Camera Wire>Multiplex Network Master Switch Assemblyewd_type=component;type=c;code=K5;pinno=3,13 |
|
| K5-3 (ILL+) - Auxiliary battery positive (+)
K5-13 (ILL-) - Auxiliary battery negative (-) |
LED illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.