Ensure that fingers or articles of clothing do not get caught in moving parts when performing this test.
85110
1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
Check the LO operation.
| *a | Component without harness connected
(Windshield Wiper Motor Assembly) |
Apply auxiliary battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(A43)Location & Routingewd_type=routing;type=c;code=A43 Click Connector(A43)Engine Compartment>Engine Room Main Wire>Windshield Wiper Motor Assemblyewd_type=component;type=c;code=A43;pinno=5,4 |
|
| A43-5 (+1) - Auxiliary battery positive (+)
A43-4 (E) - Auxiliary battery negative (-) |
Motor operates at low speed |
If the result is not as specified, replace the windshield wiper motor assembly.
Check the HI operation.
| *a | Component without harness connected
(Windshield Wiper Motor Assembly) |
Apply auxiliary battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(A43)Location & Routingewd_type=routing;type=c;code=A43 Click Connector(A43)Engine Compartment>Engine Room Main Wire>Windshield Wiper Motor Assemblyewd_type=component;type=c;code=A43;pinno=3,4 |
|
| A43-3 (+2) - Auxiliary battery positive (+)
A43-4 (E) - Auxiliary battery negative (-) |
Motor operates at high speed |
If the result is not as specified, replace the windshield wiper motor assembly.