Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM › 2020.08–2021.07
RM3700E _58 Vehicle Interior _092990 SEAT _0438369 FRONT POWER SEAT CONTROL SYSTEM D

SEAT  FRONT POWER SEAT CONTROL SYSTEM  OPERATION CHECK  


CHECK POWER SEAT FUNCTION


a.

Check the basic functions.

i.
E426773C01
2.656,1.688 2.833,1.198 2.833,1.198 3,1.198 false 1.625,2.458 1.135,1.49 1.135,1.49 0.969,1.49 true 2.552,4.198 2.385,4.198 2.385,4.198 2.094,3.771 false 2.594,4.115 2.906,4.271 0.313,0.156 10 false *a 0.771,1.406 1.083,1.563 0.313,0.156 10 false *b 3.042,1.094 3.354,1.25 0.313,0.156 10 false *c
*a Slide Function
*b Lifter Function
*c Reclining Function


Operate the power seat switches and check that each seat function operates properly:

·

Slide function

·

Lifter function

·

Reclining function





CHECK FRONT SEAT MOTOR (SLIDE, RECLINING AND LIFTER FUNCTION)


HINT:

The front power seat switch is a collective term for the front power seat switch assembly (driver seat) and the front power seat switch assembly (front passenger seat).


a.

Check the PTC operation inside the power seat motor.

NOTICE:
·

The inspection should be performed with the seat installed in the vehicle.

·

Perform the 4 steps below to check the full range of motion for each power seat function.



HINT:

The resistance of the PTC thermistor increases when a switch of the front power seat switch is held down even after the seat has been moved to the farthest possible position in one direction. If the resistance increases beyond a specified level, the current is shut off to prevent a short circuit.


i.

Choose a power seat function. Operate a switch of the front power seat switch and move the seat to the farthest possible position in one direction. Keep the seat in that position for approximately 60 seconds.


ii.

Operate the switch of the front power seat switch again and continue to try to move the seat in the same direction as in the previous step. Measure the time until the current is shut off (motor operation sound will stop).

Standard:

4 to 90 seconds



iii.

After the current is shut off, release the switch of the front power seat switch and wait for approximately 60 seconds.


iv.

Operate the same switch of the front power seat switch and move the seat in the opposite direction. Check that the motor operates.