87138C
1.INSPECT BLOWER RESISTOR
Check the resistance.
| *a | Component without harness connected
(Blower Resistor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H30)Location & Routingewd_type=routing;type=c;code=H30 Click Connector(H30)Instrument Panel>Instrument Panel Wire / Speaker Wire>Blower Assemblyewd_type=component;type=c;code=H30;pinno=1,4,2,3 |
||
| H30-1 (E) - H30-4 (HI) | Always | 3.12 to 3.60 Ω |
| H30-2 (M2) - H30-4 (HI) | Always | 0.52 to 0.60 Ω |
| H30-3 (M1) - H30-4 (HI) | Always | 1.45 to 1.67 Ω |
If the result is not as specified, replace the blower resistor.