Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT › 2020.08–2021.07
RM3700E _58 Vehicle Interior _093025 LIGHTING (INT) _0438519 PERSONAL LIGHT G

LIGHTING (INT)  PERSONAL LIGHT  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.

Check the map light.

i.
E436810C03
1.583,0.25 2,0.5 0.417,0.25 0.49,0.417 0.656,0.865 true 2.979,0.563 2.771,0.865 true 3.021,0.469 3.354,0.656 0.333,0.188 10 false +B1 0.167,0.344 0.75,0.594 0.583,0.25 10 false GND 1.708,0.281 2.021,0.479 0.313,0.198 10 false V7 0.167,0.073 0.479,0.271 0.313,0.198 10 false *a
*a Component without harness connected
(Map Light Assembly)


Apply auxiliary battery voltage to the map light assembly and check that the map light comes on.

OK:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(V7)Location & Routing

Click Connector(V7)Body>No. 1 Roof Wire>Map Light Assembly

V7-1(+B1) - Auxiliary battery positive (+)
V7-4(GND) - Auxiliary battery negative (-)
Map light switch LH on Map light LH comes on
V7-1(+B1) - Auxiliary battery positive (+)
V7-4(GND) - Auxiliary battery negative (-)
Map light switch LH off Map light LH does not come on
V7-1(+B1) - Auxiliary battery positive (+)
V7-4(GND) - Auxiliary battery negative (-)
Map light switch RH on Map light RH comes on
V7-1(+B1) - Auxiliary battery positive (+)
V7-4(GND) - Auxiliary battery negative (-)
Map light switch RH off Map light RH does not come on
V7-1(+B1) - Auxiliary battery positive (+)
V7-4(GND) - Auxiliary battery negative (-)
Map light switch off and door switch on Map light comes on
V7-1(+B1) - Auxiliary battery positive (+)
V7-4(GND) - Auxiliary battery negative (-)
Map light switch off and door switch off Map light does not come on



ii.

If the result is not as specified, replace the map light assembly.



b.

Check the door switch.

i.
E436810C02
1.583,0.25 2,0.5 0.417,0.25 2.708,0.24 2.458,0.875 true 2.042,1.271 1.729,1.708 true 2.781,0.146 3.354,0.344 0.573,0.198 10 false DOOR 1.323,1.646 1.906,1.896 0.583,0.25 10 false RLMP 1.708,0.281 2.021,0.479 0.313,0.198 10 false V7 0.167,0.073 0.479,0.271 0.313,0.198 10 false *a
*a Component without harness connected
(Map Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(V7)Location & Routing

Click Connector(V7)Body>No. 1 Roof Wire>Map Light Assembly

V7-2(DOOR) - V7-9(RLMP) Door switch on Below 1 Ω
V7-2(DOOR) - V7-9(RLMP) Door switch off 10 kΩ or higher



ii.

If the result is not as specified, replace the map light assembly.