89342A
1.INSPECT REAR CENTER ULTRASONIC SENSOR (for LH Side)
Check the resistance.
| *a | Component without harness connected (Rear Center Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(W2)Location & Routingewd_type=routing;type=c;code=W2 Click Connector(W2)Body>No. 2 Luggage Room Wire>Rear Ultrasonic Sensor Center LHewd_type=component;type=c;code=W2;pinno=4,6,1,5,2,3 |
||
| W2-4 (BI) - W2-6 (EI) | Always | 10 kΩ or higher |
| W2-4 (BI) - W2-1 (BO) | Always | Below 1 Ω |
| W2-5 (SI) - W2-2 (SO) | Always | Below 15 Ω |
| W2-6 (EI) - W2-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the rear center ultrasonic sensor.
89342A
2.INSPECT REAR CENTER ULTRASONIC SENSOR (for RH Side)
Check the resistance.
| *a | Component without harness connected (Rear Center Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(W3)Location & Routingewd_type=routing;type=c;code=W3 Click Connector(W3)Body>No. 2 Luggage Room Wire>Rear Ultrasonic Sensor Center RHewd_type=component;type=c;code=W3;pinno=4,6,1,5,2,3 |
||
| W3-4 (BI) - W3-6 (EI) | Always | 10 kΩ or higher |
| W3-4 (BI) - W3-1 (BO) | Always | Below 1 Ω |
| W3-5 (SI) - W3-2 (SO) | Always | Below 15 Ω |
| W3-6 (EI) - W3-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the rear center ultrasonic sensor.
89342
3.INSPECT REAR CORNER ULTRASONIC SENSOR (for LH Side)
Check the resistance.
| *a | Component without harness connected (Rear Corner Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(W1)Location & Routingewd_type=routing;type=c;code=W1 Click Connector(W1)Body>No. 2 Luggage Room Wire>Rear Ultrasonic Sensor Corner LHewd_type=component;type=c;code=W1;pinno=4,6,1,5,2,3 |
||
| W1-4 (BI) - W1-6 (EI) | Always | 10 kΩ or higher |
| W1-4 (BI) - W1-1 (BO) | Always | Below 1 Ω |
| W1-5 (SI) - W1-2 (SO) | Always | Below 15 Ω |
| W1-6 (EI) - W1-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the rear corner ultrasonic sensor.
89342
4.INSPECT REAR CORNER ULTRASONIC SENSOR (for RH Side)
Check the resistance.
| *a | Component without harness connected (Rear Corner Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(W4)Location & Routingewd_type=routing;type=c;code=W4 Click Connector(W4)Body>No. 2 Luggage Room Wire>Rear Ultrasonic Sensor Corner RHewd_type=component;type=c;code=W4;pinno=4,6,5 |
||
| W4-4 (BI) - W4-6 (EI) | Always | 10 kΩ or higher |
| W4-4 (BI) - W4-[1] | Always | Below 1 Ω |
| W4-5 (SI) - W4-[2] | Always | Below 15 Ω |
| W4-6 (EI) - W4-[3] | Always | Below 1 Ω |
If the result is not as specified, replace the rear corner ultrasonic sensor.