Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM3700E _59 Vehicle Exterior _093283 LIGHTING (EXT) _0440201 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.

Check that the resistance.

i.
E433464C07
1.49,0.354 1.896,0.615 0.406,0.26 1.208,1.635 1.625,1.219 true 2.083,1.615 1.792,1.229 true 1.073,1.667 1.385,1.865 0.313,0.198 10 false TB 2.115,1.635 2.427,1.833 0.313,0.198 10 false E 1.573,0.396 1.885,0.625 0.313,0.229 10 false H59 0.063,0.052 0.375,0.25 0.313,0.198 10 false *a
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(H59)Location & Routing

Click Connector(H59)Instrument Panel>Instrument Panel Wire / Speaker Wire>Hazard Warning Signal Switch Assembly

H59-6 (TB) - H59-4 (E) Hazard warning switch off 10 kΩ or higher
H59-6 (TB) - H59-4 (E) Hazard warning switch on Below 1 Ω


If the result is not as specified, replace the hazard warning signal switch assembly.



b.

Check that the illumination lights.

i.
E433464C09
1.49,0.354 1.896,0.615 0.406,0.26 1.208,1.635 1.458,1.24 true 2.083,1.615 1.948,1.24 true 1,1.667 1.385,1.885 0.385,0.219 10 false ILL+ 1.573,0.396 1.885,0.625 0.313,0.229 10 false H59 0.063,0.052 0.375,0.25 0.313,0.198 10 false *a 2.042,1.656 2.427,1.875 0.385,0.219 10 false ILL-
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Measurement Condition Specified Condition
H59-6 (ILL+) - Auxiliary battery positive (+)
H59-3 (ILL-) - Auxiliary battery negative (-)
Switch illumination illuminates


If the result is not as specified, replace the hazard warning signal switch assembly.