25860
1.INSPECT PURGE VALVE (PURGE VSV)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D25)Location & Routingewd_type=routing;type=c;code=D25 Click Connector(D25)Engine Compartment>Engine Wire>Purge VSVewd_type=component;type=c;code=D25;pinno=1,2 |
||
| D25-1 - D25-2 | 20°C (68°F) | 23 to 26 Ω |
If the result is not as specified, replace the purge valve (purge VSV).
| *a | Port (E) |
| *b | Port (F) |
| *c | Air |
| *d | Component without harness connected
(Purge Valve (Purge VSV)) |
Apply auxiliary battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).
| Condition | Specified Condition |
|---|---|
| Auxiliary battery voltage applied between terminals 1 and 2 | Air flows from port (F) |
| Auxiliary battery voltage not applied between terminals 1 and 2 | Air does not flow |
If the result is not as specified, replace the purge valve (purge VSV).