23250
1.INSPECT FUEL INJECTOR ASSEMBLY
This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.
| *a | Component without harness connected
(Fuel Injector Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(F1,F2,F3)Location & Routingewd_type=routing;type=c,c,c;code=F1,F2,F3 Click Connector(F1)Engine Compartment>No. 6 Engine Wire>Fuel Injector Assembly No. 1ewd_type=component;type=c;code=F1;pinno=1,2 Click Connector(F2)Engine Compartment>No. 6 Engine Wire>Fuel Injector Assembly No. 2ewd_type=component;type=c;code=F2;pinno=1,2 Click Connector(F3)Engine Compartment>No. 6 Engine Wire>Fuel Injector Assembly No. 3ewd_type=component;type=c;code=F3;pinno=1,2 |
||
| F1-1 - F1-2 | 20°C (68°F) | 1.34 to 1.64 Ω |
| F2-1 - F2-2 | 20°C (68°F) | 1.34 to 1.64 Ω |
| F3-1 - F3-2 | 20°C (68°F) | 1.34 to 1.64 Ω |
If the result is not as specified, replace the fuel injector assembly.