Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM3700E _51 Engine / Hybrid System _093506 HYBRID / BATTERY CONTROL _0441183 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0A1B49  Drive Motor "A" Control Module Internal Electronic Failure  


DESCRIPTION

The MG ECU, which is built into the hybrid motor control inverter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate DTC Output from Priority
P0A1B49 Drive Motor "A" Control Module Internal Electronic Failure MG ECU internal malfunction:
Calculation check error
(1 trip detection logic)
Hybrid motor control inverter assembly Comes on Master Warning: Comes on Hybrid Control A

Related Data List
DTC No. Data List
P0A1B49 -

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 2 minutes or more.

3.

With ignition switch ON and wait for 5 seconds or more.

4.

Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




PROCEDURE

1.REPLACE HYBRID MOTOR CONTROL INVERTER ASSEMBLY

NEXT

END