If the hybrid vehicle control ECU receives an invalid compressor control request from the air conditioning amplifier assembly via CAN communication, it will store this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | DTC Output from | Priority |
|---|---|---|---|---|---|---|---|
| U042481 | HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received | Invalid control request received from the air conditioning amplifier assembly
(1 trip detection logic) |
Air conditioning amplifier assembly | Does not come on | Master Warning: Does not come on | Hybrid Control | B |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>UTILITY
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Wait for 1 minute or more with the vehicle stopped, the ignition switch ON, shift lever in P and the air conditioning system on (Lo/COOL MAX, blower speed HI).
Turn the air conditioning system off and wait for 10 seconds or more with the ignition switch to ON (READY).
Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Pre-procedure1
None.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
Turn the ignition switch off.
A
B