Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › MOTOR GENERATOR CONTROL SYSTEM
RM3700E _51 Engine / Hybrid System _093506 HYBRID / BATTERY CONTROL _0441184 MOTOR GENERATOR CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  MOTOR GENERATOR CONTROL SYSTEM  P062F46  Generator Control Module(EEPROM Learning Value) Calibration / Parameter Memory Failure  


DESCRIPTION

The hybrid motor control inverter assembly monitors its internal operation and will store this DTC if it detects a malfunction of its EEPROM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate DTC Output from Priority
P062F46 Generator Control Module(EEPROM Learning Value) Calibration / Parameter Memory Failure ECU internal malfunction
(EEPROM error)
(1 trip detection logic)
Hybrid motor control inverter assembly Comes on Master Warning:
Comes on
Motor Generator A

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 2 minutes or more.

3.

Turn the ignition switch to ON and wait for 15 seconds or more.

4.

Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.




PROCEDURE

1.CHECK DTC OUTPUT (HEALTH CHECK)
a.

Enter the following menus: System Select / Health Check.


b.

Check for DTCs.

Result:
Result Proceed to
P062F46 is output from the motor generator control system. A
P062F46 is output from any system other than the motor generator control system. B



c.

Turn the ignition switch off.



A

REPLACE HYBRID MOTOR CONTROL INVERTER ASSEMBLY

B

GO TO PERFORM DIAGNOSIS FOR RESPECTIVE SYSTEM