The motor generator control ECU (MG ECU) located in the hybrid motor control inverter assembly detects the temperature of the boost converter using the temperature sensor built into the boost converter. The motor generator control ECU (MG ECU) detects malfunctions in the boost converter temperature sensor and its wiring.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | DTC Output from | Priority |
|---|---|---|---|---|---|---|---|
| P0C3811 | DC/DC Converter Temperature Sensor "A" Circuit Short to Ground | Short to ground detected in boost converter temperature sensor (upper) signal circuit
(1 trip detection logic) |
Hybrid motor control inverter assembly | Comes on | Master Warning:
Comes on |
Motor Generator | A |
| P0C3815 | DC/DC Converter Temperature Sensor "A" Circuit Short to Battery or Open | Open or short to +B detected in boost converter temperature sensor (upper) signal circuit
(1 trip detection logic) |
Hybrid motor control inverter assembly | Comes on | Master Warning:
Comes on |
Motor Generator | A |
| P0C3D11 | DC/DC Converter Temperature Sensor "B" Circuit Short to Ground | Short to ground detected in boost converter temperature sensor (lower) signal circuit
(1 trip detection logic) |
Hybrid motor control inverter assembly | Comes on | Master Warning:
Comes on |
Motor Generator | A |
| P0C3D15 | DC/DC Converter Temperature Sensor "B" Circuit Short to Battery or Open | Open or short to +B detected in boost converter temperature sensor (lower) signal circuit
(1 trip detection logic) |
Hybrid motor control inverter assembly | Comes on | Master Warning:
Comes on |
Motor Generator | A |
| DTC No. | Data List |
|---|---|
| P0C3811 | Boosting Converter Temperature (Upper) |
| P0C3815 | |
| P0C3D11 | Boosting Converter Temperature 1 (Lower) |
| P0C3D15 |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM>UTILITY
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and wait for 5 seconds or more.
Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
| Proceed to |
|---|
| NEXT |
NEXT