Home › Drivetrain › K320 (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM3700E _52 Drivetrain _092906 K320 MULTIDRIVE / CVT _0441241 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K320 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


HINT:
·

DTCs which are stored in the TCM can be displayed on the GTS.

·

The GTS can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in a consecutive driving cycle. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.



CHECK DTC


a.

Check for DTCs and freeze frame data, and write them down.

Powertrain > Transmission > Trouble Codes
50001 373
HINT:
GTS Display Description
Test Failed Shows the malfunction judgment results during the current trip.
Pending Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.)
Confirmed Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.)



b.

Check the details of the DTCs.

NOTICE:

When simulating a symptom and using the GTS to check for DTCs, use normal mode. For DTCs in the Diagnostic Trouble Code Chart subject to "2-trip detection logic", perform the following:

Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process. When the symptom has been simulated twice, the MIL will illuminate and DTCs will be stored in the TCM.




CLEAR DTC


a.

Clear the DTCs.

Powertrain > Transmission > Clear DTCs
50002 373