Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › 2020.08–2021.07
RM3700E _59 Vehicle Exterior _092999 WIPER / WASHER _0438366 WIPER AND WASHER SYSTEM D

WIPER / WASHER  WIPER AND WASHER SYSTEM  SYSTEM DESCRIPTION  


FRONT WIPER CONTROL FUNCTION


Control/Function Description
INT function Operates the front wipers intermittently at LO speed when the front wiper switch is in the INT position.
MIST function Operates the front wipers in LO when the front wiper switch is held in the MIST position.
Intermediate position return function Resumes wiper operation according to the operation of the front wiper switch or washer switch when the wipers are stopped in any position other than the lower reverse position.
Protection mode Suspends wiper operation if the wipers are prevented from operating for 10 seconds or more, in order to protect the wiper and washer system.


REAR WIPER CONTROL FUNCTION


Control/Function Description
Back door open linked wiper suspend function Suspends rear wiper operation when the back door is opened.
HINT:
·

This function is operable when its customize setting is set to "Available".

(Click here)

·

This function is disabled when the back door is closed or the vehicle speed is 7 km/h or more.



R shift position auto rear wiper operation function Operates the rear wiper 0.4 seconds after the shift lever is moved to R when the front wipers are operating.
HINT:

This function can be set to "Not Available", "Once" or "Continuance" using the customize function.

(Click here)




WASHER CONTROL FUNCTION


Control/Function Description
Front washer cooperation
·

When the washer switch is held in the Fr WASH position for 0.5 seconds or more, the front wipers operate in LO.

·

When the washer switch is released, the front wipers operate in LO for 3 additional cycles.


NOTICE:

If the washer switch is held in the Fr WASH position for approximately 40 seconds or more, operation of the windshield washer motor and pump assembly is stopped to prevent burnout, and the front wipers are returned to the park position.


Rear washer cooperation
·

When the washer switch is held in the Rr WASH position for 0.5 seconds or more, the rear wiper operates.

·

When the washer switch is released, the rear wiper operates in LO for 2 to 3 additional cycles.


NOTICE:

If the washer switch is held in the Rr WASH position for approximately 40 seconds or more, operation of the windshield washer motor and pump assembly is stopped to prevent burnout, and the rear wiper is returned to the park position.


HINT:

This function is operable when its customize setting is set to "Available".

(Click here)


Drip prevention wiper function Approximately 3 seconds after front washer cooperation completes, operates the wipers for 1 cycle to remove any remaining washer fluid.
HINT:

This function only operates when the vehicle is stopped or is being driven at a very low speed (below approximately 7 km/h (4 mph)).