Check that the voice guidance setting is not off.
Voice guidance setting is not off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H81 radio and display receiver assembly connector.
Disconnect the H82 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H81,H82)Location & Routingewd_type=routing;type=c,c;code=H81,H82 Click Connector(H81)Instrument Panel>Instrument Panel Wire / Speaker Wire>Radio & Display Receiver Assemblyewd_type=component;type=c;code=H81;pinno=22,23 Click Connector(H82)Instrument Panel>Instrument Panel Wire / Speaker Wire>Navigation ECUewd_type=component;type=c;code=H82;pinno=6,7,8 |
||
| H81-22 (SI+) - H82-6 (VOI+) | Always | Below 1 Ω |
| H81-23 (SI-) - H82-7 (VOI-) | Always | Below 1 Ω |
| H81-22 (SI+) or H82-6 (VOI+) - Body ground | Always | 10 kΩ or higher |
| H81-23 (SI-) or H82-7 (VOI-) - Body ground | Always | 10 kΩ or higher |
| H82-8 (SLD1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG