84970
1.INSPECT DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)
Check the resistance.
| *a | Component without harness connected
(Drive Mode Select Switch (Combination Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H18)Location & Routingewd_type=routing;type=c;code=H18 Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assemblyewd_type=component;type=c;code=H18;pinno=8,5 |
||
| H18-8(DRV) - H18-5(E) | Switch pushed | Below 1 Ω |
| H18-8(DRV) - H18-5(E) | Switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the drive mode select switch (combination switch assembly).
Check the illumination.
| *a | Component without harness connected
(Drive Mode Select Switch (Combination Switch Assembly)) |
Apply auxiliary battery voltage to the drive mode select switch (combination switch assembly).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H18)Location & Routingewd_type=routing;type=c;code=H18 Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assemblyewd_type=component;type=c;code=H18;pinno=4,1 |
||
| H18-4(ILL+) - H18-1(ILL-) | H18-4(ILL+) - Auxiliary battery positive (+)
H18-1(ILL-) - Auxiliary battery negative (-) |
The drive mode select switch (combination switch assembly) illumination illuminates. |
If the result is not as specified, replace the drive mode select switch (combination switch assembly).