84390B
1.INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H140)Location & Routingewd_type=routing;type=c;code=H140 Click Connector(H140)Instrument Panel>Instrument Panel Wire / Speaker Wire>Electric Parking Brake Switch Assemblyewd_type=component;type=c;code=H140;pinno=7,8,1,2 |
||
| H140-7 (SWI1) - H140-8 (SWO1) | OFF (Release) | 100 kΩ or higher |
| H140-7 (SWI1) - H140-8 (SWO1) | ON (Lock) | 10 Ω or less |
| H140-7 (SWI1) - H140-8 (SWO1) | Switch not operated | 100 kΩ or higher |
| H140-7 (SWI1) - H140-1 (SWI2) | OFF (Release) | 10 Ω or less |
| H140-7 (SWI1) - H140-1 (SWI2) | ON (Lock) | 10 Ω or less |
| H140-7 (SWI1) - H140-1 (SWI2) | Switch not operated | 100 kΩ or higher |
| H140-7 (SWI1) - H140-2 (SWO2) | OFF (Release) | 10 Ω or less |
| H140-7 (SWI1) - H140-2 (SWO2) | ON (Lock) | 100 kΩ or higher |
| H140-7 (SWI1) - H140-2 (SWO2) | Switch not operated | 10 Ω or less |
| H140-1 (SWI2) - H140-8 (SWO1) | OFF (Release) | 100 kΩ or higher |
| H140-1 (SWI2) - H140-8 (SWO1) | ON (Lock) | 10 Ω or less |
| H140-1 (SWI2) - H140-8 (SWO1) | Switch not operated | 10 Ω or less |
| H140-1 (SWI2) - H140-2 (SWO2) | OFF (Release) | 10 Ω or less |
| H140-1 (SWI2) - H140-2 (SWO2) | ON (Lock) | 100 kΩ or higher |
| H140-1 (SWI2) - H140-2 (SWO2) | Switch not operated | 100 kΩ or higher |
If the result is not as specified, replace the electric parking brake switch assembly.
Check the Illumination.
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
Apply auxiliary battery voltage to the electric parking brake switch assembly and check that the switch illuminates.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(H140)Location & Routingewd_type=routing;type=c;code=H140 Click Connector(H140)Instrument Panel>Instrument Panel Wire / Speaker Wire>Electric Parking Brake Switch Assemblyewd_type=component;type=c;code=H140;pinno=3,5 |
|
| Auxiliary battery positive (+) → H140-3 (IND+)
Auxiliary battery negative (-) → H140-5 (IND-) |
Illuminates |
If the result is not as specified, replace the electric parking brake switch assembly.