Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › 2020.08–2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0441951 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT VSC OFF SWITCH (COMBINATION SWITCH ASSEMBLY)

a.

Check the resistance.

i.
C381674C52
1.417,0.167 1.917,0.417 0.5,0.25 2.063,1.49 2.615,1.948 2.615,1.948 2.708,1.948 true 1.615,1.51 1.406,1.99 1.406,1.99 1.313,1.99 true 2.104,1.198 2.708,1.198 true 0.708,1.208 1.313,1.208 true 0.104,0.073 0.417,0.271 0.313,0.198 10 false *a 1.177,1.906 1.635,2.104 0.458,0.198 10 false + 2.75,1.115 3.167,1.302 0.417,0.188 10 false ILL- 0.375,1.115 0.792,1.302 0.417,0.188 10 false ILL+ 2.771,1.854 3.229,2.052 0.458,0.198 10 false E 1.542,0.208 1.958,0.396 0.417,0.188 10 false H18
*a Component without harness connected
(VSC OFF Switch (combination switch assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(H18)Location & Routing

Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assembly

H18-7(+) - H18-5(E) Switch pushed Below 1 Ω
H18-7(+) - H18-5(E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF Switch (combination switch assembly).



b.

Check the illumination.

i.

Apply auxiliary battery voltage to the VSC OFF Switch (combination switch assembly).

OK:
Tester Connection Condition Specified Condition

Click Location & Routing(H18)Location & Routing

Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assembly

H18-4(ILL+) - H18-1(ILL-) H18-4(ILL+) - Auxiliary battery positive (+)
H18-1(ILL-) - Auxiliary battery negative (-)
The VSC OFF Switch (combination switch assembly) illumination illuminates.


If the result is not as specified, replace the VSC OFF Switch (combination switch assembly).