This DTC is stored when a door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2795 | Unmatched Key Code | A door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). | ·
Door control transmitter assembly ·
Transponder key ECU assembly |
Immobiliser | A | DTC Output Confirmation Operation:
Insert the door control transmitter assembly into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2795 | - |
If the transponder key ECU assembly or a door control transmitter assembly is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Perform "DTC Output Confirmation Operation" procedure.
Procedure1
Check for DTCs.
If DTC B2795 is stored, check for DTCs with the next door control transmitter assembly after clearing the DTCs.
DTC B2795 is not output.
| Result | Proceed to |
|---|---|
| B2795 is not output | A |
| DTC B2795 is output for all of the door control transmitter assemblies | B |
| DTC B2795 is output for any of the door control transmitter assemblies | C |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Check that the ignition switch can be turned to ON using the door control transmitter assembly for which the DTC was stored.
Ignition switch can be turned to ON using the door control transmitter assembly (for which the DTC was stored).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Reregister the key ID code with the transponder key ECU assembly.
Registration procedure can be completed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG