This DTC is stored when a door control transmitter assembly is inserted into the ignition key cylinder but no communication occurs between the door control transmitter assembly and transponder key ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2796 | No Communication in Immobiliser System | The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*). | ·
Door control transmitter assembly ·
Wire harness or connector |
Immobiliser | A | DTC Output Confirmation Operation:
Insert the door control transmitter assembly into the ignition key cylinder. |
| B2798 | Communication Malfunction No. 2 | Key ID code identification cannot be completed within the specified time (1 trip detection logic*). | ·
Door control transmitter assembly ·
Wire harness or connector |
Immobiliser | A | DTC Output Confirmation Operation:
Insert the door control transmitter assembly into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2796 | - |
| B2798 | - |
If the door control transmitter assembly is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Pre-procedure1
Disconnect the H74 transponder key ECU assembly connector.
Disconnect the H73 transponder key coil connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H74,H73)Location & Routingewd_type=routing;type=c,c;code=H74,H73 Click Connector(H74)Instrument Panel>Instrument Panel Wire / Speaker Wire>Transponder Key ECU Assemblyewd_type=component;type=c;code=H74;pinno=2,3 Click Connector(H73)Instrument Panel>Instrument Panel Wire / Speaker Wire>Transponder Key Coilewd_type=component;type=c;code=H73;pinno=1,5 |
||
| H74-2 (ANT1) - H73-1 (ANT1) | Always | Below 1 Ω |
| H74-3 (ANT2) - H73-5 (ANT2) | Always | Below 1 Ω |
| H74-2 (ANT1) or H73-1 (ANT1) - Other terminals and body ground | Always | 10 kΩ or higher |
| H74-3 (ANT2) or H73-5 (ANT2) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG