15370
1.INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Cam Timing Oil Control Solenoid Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D17)Location & Routingewd_type=routing;type=c;code=D17 Click Connector(D17)Engine Compartment>Engine Wire>Cam Timing Oil Control Solenoid Assembly (Exhaust Side)ewd_type=component;type=c;code=D17;pinno=1,2 |
||
| D17-1 - D17-2 | 0 °C (32 °F) | 6.3 to 7.3 Ω |
| D17-1 - D17-2 | 20 °C (68 °F) | 6.9 to 7.9 Ω |
| D17-1 - D17-2 | 40 °C (104 °F) | 7.4 to 8.6 Ω |
If the result is not as specified, replace the cam timing oil control solenoid assembly.
Stroke Amount Inspection
| *a | Shaft Side Facing Down |
| *b | Shaft Side Facing Up |
| *c | Shaft |
Using vernier calipers, measure length (A) and (B) with the shaft of the cam timing oil control solenoid assembly set in the respective positions shown in the illustration.
Do not apply auxiliary battery voltage to the terminals of the cam timing oil control solenoid assembly.
If the shaft does not extend under its own weight, extend the shaft with your fingers.
Calculate the stroke amount based on the difference of length (A) and (B).
Stroke amount = length (A) - length (B)
If the value is not as specified, replace the cam timing oil control solenoid assembly.
| Specified Condition |
|---|
| 4.3 mm or higher
0.169 in. or higher |