Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › ACCELERATOR PEDAL
RM3700E _51 Engine / Hybrid System _093766 M15A-FKS ENGINE CONTROL _0442021 ACCELERATOR PEDAL G

M15A-FKS ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accel Position Sensor No. 1 Voltage and Accel Position Sensor No. 2 Voltage.

Powertrain > Engine > Data List
Tester Display
Accelerator Position Sensor No.1 Voltage
Accelerator Position Sensor No.2 Voltage
50003 372 87,88

e.

Read the values displayed on the GTS.

Standard Voltage:
Tester Display Condition Specified Condition
Accelerator Position Sensor No. 1 Voltage Accelerator pedal is fully released 0.5 to 1.1 V
Accelerator pedal is fully depressed 2.6 to 4.5 V
Accelerator Position Sensor No. 2 Voltage Accelerator pedal is fully released 1.2 to 2.0 V
Accelerator pedal is fully depressed 3.4 to 4.75 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.