Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › MASS AIR FLOW METER › 2020.08–2021.07
RM3700E _51 Engine / Hybrid System _093766 M15A-FKS ENGINE CONTROL _0442022 MASS AIR FLOW METER G

M15A-FKS ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the value of Data List item "Mass Air Flow Sensor" using the GTS.

NOTICE:

Perform the inspection of the mass air flow meter while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).


i.

Vehicle is made into the following state.

1.

Turn off all electrical loads, such as the air condition, etc.

2.

Check that the coolant temperature is 75 °C (167 °F) or more.

3.

Put the Shift Lever in the N position.



ii.

Connect the GTS to the DLC3.


iii.

Start the engine.


iv.

Turn the GTS on.


v.

Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.

Powertrain > Engine > Data List
Tester Display
Mass Air Flow Sensor
50003 372 215

vi.

According to the display on the GTS, read the Data List when the engine is running.

Standard Condition:
GTS Display Condition Specified Condition
Mass Air Flow Sensor Idling 1.5 to 2.7 gm/sec
3000 rpm 4.0 to 8.0 gm/sec


If the result is not as specified, replace the mass air flow meter.

If the result is within the specified range, remove and inspect the mass air flow meter.

HINT:

Click hereEngine / Hybrid System>M15A-FKS (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION




Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the mass air flow meter.

HINT:

Click hereEngine / Hybrid System>M15A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION